This started life as a Reference Lenco MKI, and was steadily upgraded over the years to a full Reference Lenco MKIII before finally being traded towards an Ultimate Lenco.  The recipe for my Reference plinths has not changed over the years, after all it is proven, the only ‘tables in…

Here is an extremely rare event, a Reference Lenco MKIII, the precursor to the Ultimate Lenco, this one traded towards the Ultimate Lenco.  This one was built for air-bearing tonearms on the right, with a 12″ tonearm board on the upper left.  The air-bearing tonearm in question is the Cartridge…

Very Rare Goldring Lenco ’88 in 75-pound Classic plinth, fully updated to MKII specifications This was Goldring’s design, an answer to the Garrard “motor unit” style. The Goldring reworking of this design (Garrard 301) is visually very successful, being more streamlined and modern-looking, preserving the low-profile Lenco platter style. Though…

This Garrard 401 has been fully-rebuilt and restored by me using my specialized idler-wheel-drive rebuilding techniques, and so is as with all my work dead silent with no hint of rumble, and extreme levels of information-retrieval. It comes with Kokomo bearing kit and Bearpaw footers and hard acrylic mat included.…

This is available and ready for rebuilding to either Classic levels (includes comprehensive restoration and improvement of the machine itself), or to Reference levels. I have already done one according to the Reference recipe and it responded very well with superb retrieval of fine detail. All my rebuilds are dead…

I have a rebuilt Sony 2250 in heavy Classic plinth, finished in jatoba veneer, which may not match a rebuilt Lenco but will outperform very high-end belt-drives easily up to the $10K range, and also outperform the famed Technis SP-10 mKIIs in similar rebuilds (being much more fluid and openly…

I have acquired a classic Koetsu SA-1100D MKII tonearm, in the box, with all fittings, fluid damping, screws, headshell, cable, with not even a mark on the headshell. In addition to the fluid damping, it also has on-the-fly VTA set into the base. To match to it, I also have…